Training

1. VCA WFPR (WORKING ON FLANGES ACCORDING TO PROTOCOL).

1. Pre-Training (If required)
2. Presentation
3. Exam (Theory)
4. Practical Exam

2. VCA WFPR T&T (WORKING ON FLANGES ACCORDING TO PROTOCOL WITH TORQUE AND TENSIONING EQUIPMENT.

1. Pre-Training (If required)
2. Presentation
3. Exam (Theory)
4. Practical Exam

3. HARNESS AWARENESS/SUSPENSION TRAUMA. THEORY AND PRACTICAL ASSESSMENT CONSISTING OF:

1. Presentation
2. Legislation
3. Damage/Fault/Validity check of the harness
4. Suspension trauma facts
5. Correct wearing of harness

4. WORKING AT HEIGHTS AWARENESS. (THIS COURSE IS OFFERED IN CONNECTION WITH THE HARNESS AWARENESS COURSE)

Theory presentation consisting of:

1. Background
2. Scope
3. Managing risks
4. Selection of equipment
5. Other requirements

5. MANUAL HANDLING AWARENESS

1. Pre-assessment test (to assess candidates’ knowledge)
2. Presentation
3. Spinal awareness
4. Principles of safe handling
5. Risk assessments
6. Using T.I.L.E to assess the risk. (Task, Individual, Load, Environment & Equipment)

6. CONFINED SPACE AWARENESS

Theory and practical assessment consisting of

1. What is a confined space?
2. Identify a confined space
3. Atmosphere testing Duties
4. Confined space atmosphere
5. Duties of the attendant

7. ON SITE MACHINING (IN SITU)

7a. Pipe cutting with a clamshell.

1. Getting familiar with the equipment
2. Maintenance of the equipment
3. Safely use of this equipment
4. Grinding and sharpening of toolsteels
5. Mounting and lining up the clamshel
6. Pipe cutting
7. Bevelling
8. Counter bevelling
9. Tapering
10. Measurement of the angel

7b. Flange facing

1. Getting familiar with the equipment
2. Maintenance of the equipment
3. Safely use of this equipment
4. Mounting and lining up the FF machine
5. Machining a Rased face
6. Machining a Full face
7. Machining a Tung and Groove
8. Machining a male and Femeale
9. Machining a RTJ
10. Roughness measurement

7c. Lineboring

1. Getting familiar with the equipment
2. Maintenance of the equipment
3. Safely use of this equipment
4. Mounting line bore machine
5. Clocking out the axel
6. Measure the hole
7. Machining the hole
8. Measure the hole after machining
9. Facing with a line bore

7d. Drilling in Situ

1. Getting familiar with the equipment
2. Maintenance of the equipment
3. Safely use of this equipment
4. Mounting magnet base drill machine
5. Right chose or drill
6. Use of adapters or guides
7. Drilling the hole
8. Measure the hole after drilling